Skip to Main text

Head damage error occurs. How should I take care of this?

Replace the thermal head with a new one. This will solve the problem if the head damage error is due to a broken wiring.

  • To change the thermal head, please refer to the printer’s operation manual.
  • Use caution not to damage or contaminate the new thermal head during replacement.
  • Do not touch the heating element of the thermal head during replacement.
  • Chlorine in the finger’s sweat may damage the protective layer of the thermal head. If you touched the heating element, clean it immediately.
  • After the thermal head has been replaced, gently wipe the heating element with a cleaning agent such as isopropyl alcohol (IPA).

To ignore a head error

If there is no spare thermal head but printing must be continued even if the print quality is low, the head error can be ignored by holding down the [LINE] switch for 2 seconds.

(This will result in a white stripe in printing where the wiring is broken.) Until the printer is rebooted, the error of this particular dot will be ignored, and printing can be continued.

Questions about this Category
  • What are the system requirements to print a label?
  • What interfaces other than a USB port is available?
  • What is the wiring configuration of the RS232C cable?
  • Can a label and ink ribbon for SR/SRS be used?
  • The printer does not work if it is connected to a different USB port on the computer.
  • How do I check which USB port is registered on the printer driver?
  • Can I use memory cards?
  • What are the options available?
  • The print quality is deteriorated.
  • Label error occurs. How should I take care of this?
  • The print position is misaligned.
  • I have installed the printer driver for Windows 7, but I cannot find the icon for it.

Contact Us

Customer Support Center

Business Hours(XXXX time)00:00-00:00(Except for Sat, Sun, and Holidays)

  • TEL XXXX-XXXX-XXXX
  • FAX XXXX-XXXX-XXXX

Back to Page Top